Seat Belt Tensioner Control Module Reset
Prerequisites:
New Seat Belt Tensioner installed
Battery voltage no less than 12.4 V.
Seatbelt must NOT be plugged in.
No Component Protection, Control Module Faulty, Crash Data Stored, Control Module Not Coded or Igniter faults in the system.
Fault such as B1304 - Left front seat belt tensioner control module: Not configured and B1305 - Right front seat belt tensioner control module: Not configured are normal prior to the matching procedure.
Warning message on dash "Audi Pre Sense System Fault!" may be displayed when ignition is turned on.
[Select] [15 - Airbags] [Security Access - 16]
Enter the Basic Settings Enabling (Belt Tensioners) code shown in the pop-up balloon to enable the basic setting. [Do it!] [Basic Settings - 04]
Select Left belt tensioner serial number -or- Right belt tensioner serial number depending on the new component(s). When applicable type the single digit 0 into the (reserved) box. If this is not present skip this step. [Go!] to activate the Basic Setting.
After the result of Finished Correctly appears click [Stop]
The reset has been performed. If both belts were replaced repeat for the other side at this point [Done, Go Back] [Fault Codes - 02] Faults should NOT be stored [Close Controller, Go Back - 06]
ако това го направя дали ще се получи, единствено се чудя кой е серийния номер на обтегача, който се иска да се въведе